6 Safety Measures to Follow When Using Film Lighting

Shooting a film may be a stressful experience, especially if you are working on a larger production. In such scenarios, the challenges and expectations will both be higher. You have got a lot of people going about with a lot of things - some with sharp stuff, some others with hot stuff and maybe a few with heavy stuff. So, maintaining your workspace and keeping it in order is quite critical. Keeping your set as orderly as possible can not only keep your cast and crew safe but it will also help your set run more efficiently. Thus, when the stage or film lighting equipment is set up, like exhibition rigging, following some safety measures is necessary

Film sets are teeming with potentially lethal equipment such as scorching lights, cables and soaring voltage. Mishandling any of these items might result in catastrophic consequences which is why it is critical to understand how to keep your set as safe as possible. The following 6 safety recommendations will make your cast, crew and set much safer than before. Take a look at them below and remember them:

1.    Always tech scout your potential locales:

In the event of an emergency, locate possible threats, power sources and escape routes. You can keep them marked out with neon paints so that they can glow even when the film lighting Australia and others are switched on. Keeping your crew members abreast with these exit or escape points will help them to escort those who are not aware of the same.

2.    Locate and divide your circuits:

You do not want to trip a fuse by plugging in too much at once. So, check if there are multiple plug-in points. This might help in avoiding short circuits or fighting for plugging in too many pieces of equipment.

3.    Locate the breaker box:

If you happen to blow one, it is a good idea to know where it is before all the lights go out. Therefore, it is essential to know where the breaker box is. Even when it is pitch dark, you can still locate it.

4.    Maintain fire marshal compliance:

Ascertain that there is a safe escape from the building in the event of an emergency. So, avoid blocking exits or entrances with any sort of lighting equipment for film lighting Australia and in other locations. Also, always leave at least 2 feet of space along your evacuation path.

5.    Cable management and organisation:

It is quite simple - just tape down all of your cords so no one trips over them. You can even push them under the carpet and make sure no one trips over the cords.

6.    Communicate with your team as follows:

Whether you are turning a corner with a C-stand or spotting a possible danger, it is always a good idea to communicate clearly and often with your team. As a result of this, your team will know what to do if there are any sort of emergencies.

 Flick Switch Pty. Ltd. is known for exhibition rigging and other rigging services. They not only maintain these safety measures but also inform everyone present around about the safety tips.